Supported Models

A single firmware image runs the controller web interface across the whole Supracontrol controller range. The controller reports its model when the interface loads, and the interface adjusts which pages and options it shows. This article lists the models and the differences to expect.

Controller models

Model	Controller
TH100	Temperature and Humidity Controller
DC50	Single Door Controller
DC102	Door Controller
RC102	Rack Controller
BC100	BUS Controller
EC50	Environment Controller
CMC250	Cabinet Monitoring Controller
RMC100	Room Monitoring Controller
RMC304	Room Monitoring Controller
BMC100	BUS Monitoring Controller
BMC250	BUS Monitoring Controller
MODBUS	MODBUS Controller
RTU	RTU Controller
PLC10	Programmable Logic Controller

How the interface adapts

The pages and options differ only in a few well-defined places; everything else is identical across models.

Difference	Applies to
Card Reader and Lock pages hidden	EC50, BC100, BMC100, BMC250 - models without access-control hardware.
24 V lock output option hidden	DC50 and RMC100 - the Lock page omits the 24 V voltage option.
Card-reader protocol choices	The protocols offered on the Card Reader page depend on the wiring channel’s capabilities (RS-485 / Wiegand).

Note: If a page described elsewhere in this documentation is missing on your controller, check this list first - it is almost always because the model does not carry that hardware.

See also: Introduction | Navigation | Card Reader | Lock